The assembly instructions for this kit are very good, but its an excellent idea to follow the warning in the READ THIS FIRST box on step 2! Why? Well, its not so obvious, but one bogie on each side for the VVSS suspension is different than the others. The flat part has a slight angle (parts A14 and A15). These two parts must go in a specific location and they are not interchangeable with the other bogies. Surprisingly, the instructions does not make note of this, but I noticed it when carefully examining the parts and test fitting. It would be easy for a new modeler or a rushed modeler to miss this little detail. Especially since the other parts (A12, A13, A16, A17) can be press fitted into the location for A14 and A15.
A note about step 2. The angle of the hatch (part D02) is correctly shown for an open hatch. These hatches did not open all the way (180 degrees). Some modelers get this wrong. Also, except for that tab piece, parts A19 and D03 are the same.
