Rubicon Models > Official Assembly Instructions
280048 SdKfz 250/251 Expansion - SdKfz 250/9 & 251/23 - 2cm Autocannon
Rubicon Models:
Assembly Instruction for SdKfz 250/251 Expansion - SdKfz 250/9 & 251/23
Last Update: 170703
oreoc23:
I've been looking at the instructions of the SdKfz 250/9 kit... I currently have 2 of the SdKfz 250/1 Neu Kits, but have not purchased the SdKfz 250/1 Alte yet. The Instructions below show both kits for the SdKfz 250/9 using the Floorboard Part E22 in the building of both the SdKfz 250/9 Alte & SdKfz 250/9 Neu... Since the Expansion Kit SdKfz 250/9 has only one Part E22, can I assume I should use it in the SdKfz 250/9 Alte so as to attach the 20mm KwK 38 Autocannon to the Floor of the SdKfz 250/9 Alte and leave the SdKfz 250/9 Neu without the Floorboard? :o
Pinky:
The instructions say that part 22 is only for the alte version. The neu version didn't have the pedestal - the 20mm was attached to the (redesigned) turret.
ultravanillasmurf:
--- Quote from: Pinky on February 09, 2018, 12:24:07 pm ---The instructions say that part 22 is only for the alte version. The neu version didn't have the pedestal - the 20mm was attached to the (redesigned) turret.
--- End quote ---
Step 5 is for the neu, and seems to use the part E22 (without the step 2a holes).
I would just put a black painted rectangle of plastic card in the bottom of the hull. You probably cannot see past the turret gubbins. Unless you are Ripley and have opened the back door ^__^.
Pinky:
You're right, UVS - I've got the kit, but haven't built it. But surely the floor isn't needed?
Navigation
[0] Message Index
[#] Next page
Go to full version