Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - elias.tibbs

Pages: [1] 2 3 ... 19
1
General Discussions / Re: What's Warlord up to?
« on: April 26, 2018, 03:25:29 PM »
Warlord US infantry is out in the next month or so and the Perry ones, we’ll they only had 2 greens done and it’s a side project so let just say “at some point”.

Rubicon infantry aren’t the same as the perry for scale, they are noticibly more slender and to scale. That said, I think you can easily get away with mixing and matching Rubicon and Perry without too much issue.

2
And the same request when you get around to doing the M4A3 (75) too..

3
Yep!

4
Would be nice to get a small and large hatch version

5
Work In Progress / Re: Digital Sculpts - British Helmets 180422
« on: April 22, 2018, 10:12:46 PM »
Very few actually wore the helmet though. Crews hated it. Probably a contributing factor in the higher deaths and casualties than the US in the same tanks.

6
General Discussions / Re: What's Warlord up to?
« on: April 18, 2018, 02:09:36 PM »
These must be a replacement for the current US Army figures.  They do look better.

They’re the perry ones, not warlord. Although warlord are releasing new US infantry soon.

Scale wise, it’s not too bad. If warlord is heroic and rubicon is true, Perry is somewhere in the middle towards the true side.

7
General Discussions / Re: What's Warlord up to?
« on: April 17, 2018, 04:02:47 AM »
If they’re using Renedra (which they will), it’ll be a while.

8
General Discussions / Re: What's Warlord up to?
« on: April 16, 2018, 03:24:24 PM »
Crocodile is a resin/metal upgrade kit for their existing M4 kit.

Which means I’ll buy it and put the extra bits on a Rubicon Sherman instead.

9
General Discussions / Re: Salute 2018 - Thank You 190415
« on: April 16, 2018, 12:07:31 AM »
Plastics and resin I use the plastic Soldier Company primer.

For JTFM resin I use a Halfords enamel primer first.

10
General Discussions / Re: Salute 2018 - More info... 180412
« on: April 15, 2018, 08:08:07 PM »
Die Waffenkammer's resin was still a bit slippery even after a scrub with scourer, the area between the driver and gunner on the Comet was a bit resistant to paint.

Jeff uses a different type of resin than what we’re used to. You have to use an etching primer or enamel primer. But yes, also need very good scrubbing!

11
General Discussions / Re: Salute 2018 - More info... 180412
« on: April 15, 2018, 03:02:39 PM »
Drying?

Arent all the kits pre cleaned/washed?

12
General Discussions / Re: Salute 2018 - More info... 180412
« on: April 13, 2018, 04:19:39 AM »
Group picture on Saturday anyone?

13
General Discussions / Re: Q1/2018???
« on: April 07, 2018, 07:53:05 PM »
It’ll probably be 2 sets of each of the US stuff, jeep trailer, Patton and 1 of each of the French vehicles for me.

14
General Discussions / Re: What's Warlord up to?
« on: April 06, 2018, 02:40:23 PM »
Don’t trust the box art though, their current M4 plastic kits has a large hatch on the front of the box..

15
General Discussions / Re: What's Warlord up to?
« on: April 05, 2018, 10:52:34 PM »
If they put a crocodile trailer on an M4A4 then they’ve cocked it up right away! Should just be a standard M4, so either they’ll use the existing plastic kit with either plastic or resin add ons  (boo, it’s rubbish..), bring out a new plastic M4 (very doubtful), have this as a fully resin kit (no issue with this) or use their M4A4 kit (wouldn’t put t past them..).

Pages: [1] 2 3 ... 19