Rubicon Models
Rubicon Models => Official Assembly Instructions => Topic started by: Rubicon Models on April 03, 2015, 11:28:19 am
-
Assembly Instruction for the StuG III Ausf G
INSTRUCTION HAD BEEN UPDATED
PLEASE CHECK POST BELOW...
-
Do the barrels need to be glued in, or can they be slid on and off for swaps after assembly?
-
Do the barrels need to be glued in, or can they be slid on and off for swaps after assembly?
You mean the "gun barrels"? Yes, if you wanted to...
Just make sure you don't have too much paint on the contact point, otherwise will be too tight to remove!
;D
-
We have caught a part label error on our StuG III Ausf G assembly instruction sheet:
(http://i1373.photobucket.com/albums/ag377/RubiconModels/StuG%20III%20Ausf%20G/StuG%20III%20Manual%20Error%2001_zps3op0yu5p.jpg)
Sorry for the inconvenience!
:-[
-
(http://i1373.photobucket.com/albums/ag377/RubiconModels/Assembly%20Instructions/280017%20StuG%20IIIG%20Manual%20160325-1_zpsuvujmdta.jpg)
(http://i1373.photobucket.com/albums/ag377/RubiconModels/Assembly%20Instructions/280017%20StuG%20IIIG%20Manual%20160325-2_zpsgntrdbfw.jpg)
(http://i1373.photobucket.com/albums/ag377/RubiconModels/Assembly%20Instructions/280017%20StuG%20IIIG%20Manual%20160325-3_zpsnshppjzw.jpg)
(http://i1373.photobucket.com/albums/ag377/RubiconModels/Assembly%20Instructions/280017%20StuG%20IIIG%20Manual%20160325-4_zpskgfpiwgd.jpg)
Last Update: 160325